Tyco Electronics FOSC-600 C, Руководство по установке

Страница: 12 / 16

12
3.8.4 Place the top half of the closure body onto the bottom half.
Turn top half upside down and at a 45 degree angle. The latches
should fall into place.
3.8.5 Use a nut driver to tighten the captured bolt at each end
of the closure.
Secure all latches around the outside of the closure by inserting a
screwdriver into each latch. Check the bolts again to make sure
they are tight.
3.8.6 In the ports which are not used, install a plug.
3.8 Closing the closure
3.8.3 Make sure that the latches are properly aligned.
3.8.1 Place silica gel on the tray. When tower is fully loaded with
trays, place silica gel at the side of the trays (between the trays and the
Velcro).
3.8.2 Make sure that the rubber gasket in the bottom half of the
closure is clean and well secured in the groove.