http://www.CompeGPS.com http://Support.CompeGPS.com 68
8.8.1.3 Calculation method
Before you start navigating, it is very important to chose if the planned route that
you are about to navigate will be automatically calculated by:
The shortest way
The fastest way
8.8.2 Next waypoint
When navigating a route, you can select a required event to validate a waypoint
and switch to the following one:
Radius of the next waypoint:
Enter inside the radius of the next waypoint
(only that one).
Radius of any next waypoint:
Enter inside the radius of any of the next
waypoints (next one and any of the succeeding waypoints).
Roadbook mode:
When entering the radius of any waypoint, it will be set
as next. When going out of it, next one will be activated. When following a
roadbook it is required to show the information of the current waypoint
while in its surroundings. This way, instructions for each point can be
followed correctly.
Bisector inside next waypoint:
Enter inside the radius of next waypoint
and cross the bisector that is formed with the previous and next waypoint.
Bisector inside next waypoint or 10% of any waypoint:
Same as the
previous, but if any waypoint is quite near (10% of its radius) it will be
validated and the next one will be activated.
Only buttons bar:
Never change to next waypoint automatically, only
manually when
'Next waypoint' or
'Previous waypoint'
buttons are pressed.
A default radius can be assigned for route waypoints, this value will be taken
when this information is not available. If radius for a concrete waypoint of the
route is defined, it will be respected. But in case that waypoint does not have a
specific radius, the default one will be used instead.
8.8.3 Estimated times
Configure the preferences to automatically calculate the estimated time of
destination arrival: