TV One C2-8000 Series, Руководство по эксплуатации

Страница: 78 / 136

C2-8000 S
ERIES
O
PERATION
M
ANUAL
74
10.3 Basic setup of the two projectors
The above diagram shows how the two projects should be placed to create a wider
than normal image. The amount by which they overlap is very important, as this will
also relate to the zooming values to be used for each of the CORIO®2 scaling
engines.
Zooming is required because each projector is showing slightly more than half of
the projected image, and thus each channel needs to be zoomed into a different
area of the original source picture.
At this point, it is only necessary to place the projector roughly where you would like
them to be, with around 15% overlap horizontally. If your projectors are already
fixed into position, check that there is around 10% to 20% overlap, or edge-blending
will not be possible.
You must also ensure that both projects are in focus with the same zoom settings (if
your projector has this). It is often worth doing a ‘factory reset’ on them to ensure
that no other settings (such as gamma correction or tilt) are active.
10.4 Connections to the scaler(s) and projectors
For CORIO®2 units with two scaling engines (such as the C2-7000 and C2-8000
series), use outputs 1 and 2 to connect to the left and right projectors respectively.
If two single-channel scalers (such as the C2-1000 or C2-2000 series) are used,
then connector unit ‘1’ to the left-most projector, and unit ‘2’ to your right-most
projector. Hereafter, we’ll talk about Output 1 and Output 2 as referring to unit 1’s
output and unit 2’s output.
Basic video projector setup showing overlap.