Tuttnauer TIVA2 TD, Инструкция по эксплуатации

Страница: 20 / 56

20
English
The flow meters of chemicals are calibrated according
to the density of these tested products which ensure
correct operation.
The following combinations of process fluids have been
tested to verify the compatibility of the materials with
the components inside the device, for devices placed
on the market starting from the 1
st
of July 2019.
Liquids recommended:
Manufactu-
rer
Detergent Neutraliser Rinse aid
Borer
(1)
Deconex
Prozyme
Alka-X
Deconex 64
Neutradry
Tuttnauer Tuttnauer
Alkaline
Detergent
Tuttnauer
Neutralizing
Agent
1) For the manual pre cleaning of the instruments
stored inside the cassettes use: Borer Deconex Prozyme
Active.
When chemical levels are low, a warning message
appears on the display.
Chemical products dosing is set to an average value as
recommended by the manufacturer.
When the actual dosing of the chemical exceeds the
tolerance of 5%, the system goes into alarm.
a
WARNING: Use only the chemical products
indicated in the table. The use of non-
certified products will void the warranty.
6 Using the machine
Before starting the machine, the operator in charge
must have read and understood this whole manual,
in particular the information given in section «3 Safety
and prevention».
Furthermore, before starting work, check that the
machine is in order and that all parts subject to wear
and deterioration are fully efficient.
6.1 Commissioning instructions
These control operations (reported below) are
performed to check if the machine works properly and
should be performed when the machine installation is
completed.
1) Open the tap that supplies water to the machine.
a
WARNING. The water should NOT flow
into the tank; otherwise the water loading
solenoid valves (in the lower compartment
of the machine) are dirty or blocked due to
long storage in the warehouse and therefore
they must be cleaned. Check that there are
no water leaks in the pipe fittings.
2) Check that the suction tubes (located in the lower
part of the machine) within the corresponding
containers/tanks containing the liquids provided
(detergent, neutraliser, and/or others), are correctly
inserted (onlyu UC version).
3) Using the main circuit breaker, supply power to the
machine.
4) Check that the water supply flexible hoses are
properly connected.
5) Start the machine using the ON-OFF switch (1 Fig.
13).
6) At the beginning of the first cycle check the level
probes of the liquid suction tubes (detergent,
neutraliser and/or others): pull one tube at a time
out of the container and check if the corresponding
alarm flashes on the display, indicating the need for
liquid refilling (only UC version).
7) After running 3-4 washing tests, clean the water
filters placed in the lower compartment of the
machine (Fig. 9).
8) Check that the drain trap does not show water leaks
and is firmly secured to both the machine and the
drain.
9) Check if the pumps correctly suck washing liquids.
To do this, check that the liquid rises along the tube
connected to them.