Turnigy 9XR, Руководство пользователя

Страница: 32 / 37

Templates (11/11)
The templates are there to help you get started. When entering the screen you'll see a list of
available templates. To choose a template, scroll down to it and press [MEU LONG]. This will
add
the template to the existing mixes.
Channel order:
This will allow you to set the way the templates are written to the mixers.
RETA means RUD = 1, ELE = 2, THR = 3, AIL = 4.
AETR means AIL = 1, ELE = 2, THR =3, RUD = 4.
At the bottom you'll see an option called “CLEAR MIXES [MENU]”. Pressing [MENU LONG] on this
will clear all the mixes leaving you with a clean slate.
The templates are:
1. Simple 6-CH: Plain vanilla 6-ch airplane.
2. T-Cut: This adds a throttle cut mix on your throttle channel.
3. V-Tail.
4. Elevon\Delta.
5. Heli Setup: This will clear your mixes and curves and setup a preliminary eCCPM heli.
6. Gyro Setup: Once you have the gyro setup, then go setup your TX so that the stick
direction is correct.
Just like a flybarless system, you are not controling the servo directly. The gyro's head
holding ability and your ability to make yaw changes are two seperate operation as far as
the gyro is concerned.
7. Servo Test: This will setup a servo test output on CH15. To test your servos choose the
mixer's source as CH15. It will cycle slowly between -100 and 100.
TEMPLATES 11/11
01 Simple 6-ch
02 T-Cut
03 V-Tail
04 Elevon\Delta
05 Heli Setup
Channel Order RETA