Turnigy 9XR, Руководство пользователя

Страница: 30 / 37

Custom Switches (9/11)
Custom switches are not really switches at all but rather a set of logical conditions that can be used
as switches.
You might have noticed that beyond the physical switches there are 6 switches called SW1..SW6.
These correspond to the list you see in this screen. Once the condition defined for the switch is
met it's value will be“ON”.
1. First we define the condition. This can be v>offset, v<offset, |v|>offset and |v|<offset, or it can
be a logical condition: AND, OR, XOR, or it can be an evaluation between 2 sources.
2. If you've selected a regular condition you need to specify a source and an offset:
i. The source can be a stick, a pot, a PPM input or an output channel.
ii. An offset can be anywhere between -100 and 100. This will be the test point for the condition.
3. If you've selected a logical condition the switch results the condition applied to the 2 selected
switches.
For example: OR ID1 ID2 will be “ON” if either ID1 or ID2 is on.
4. If you've selected an evaluation you (“==”, “>”, “<” etc...) you need to select the 2 sources to
evaluate between.
For example: Switch on only if CH1 is less th an RUD → V1<V2 CH1 RUD
Example: Say you have a glow plug driver which you want to turn on when the throttle is below
10%:
1. Highlight SW1
2. Select the source as THR.
3. Select the offset as -80 (remember -100 – 100 so 10% from idle is -80).
4. Select the condition as v<ofs.
Now you need to use a mix to run the switch. Go to the mixer menu. Select the CH8 as the channel
you want the GP driver to operate on. On that channel select source as “MAX” and Switch as
“SW1”. Now whenever the throttle goes below 10%, CH8 will go to 100%.
CUSTOM SWITCHES 9/11
SW1 v<ofs THR -60
SW2 ----
---- 0
SW3 ---- ---- 0
SW4 ---- ---- 0
SW5 ---- ---- 0
SW6 ---- ---- 0