Turnigy 9XR, Руководство пользователя

Страница: 27 / 37

Limits (6/11)
This is probably the second most important menu.
The limits operate on the output channels (as you can see from the flow chart in the introduction).
In the LIMITS menu you can set the center point (subtrim), limits (both left and right)
Each channel here corresponds to a channel in your receiver. The limits you set will be used on that
channel only.
Columns:
1. subT: SubTrim. This sets the channel's center point.
HINT: The values of subT can be -100 to 100 with increments of 0.1. This is done so to have
excellent resolution when setting the center of each surface. You can use your stick to set
the center point as well. While the subT is highlighted hold the stick so that the surface is
centered. Press [MENU LONG] and the position will be recorded!
2. Min/Max: These set the endpoints of the channel.
Notice that there's a telltale that hints as to which side is active at the moment. Each limit
point can range between -100% to 100%. The limits act both as gains and as absolute limits.
The servo will not go beyond the limits you set here.
LIMITS 6/11
CH1 -5.9 -10 0→ 100
CH2 0.7 - 100→ 100
CH3 0.0 - 95 ← 40
CH4 -14.4 - 100→ 100
CH5 45.9 - 100→ 100
CH6 0.0 - 100→ 100