16
17
Platzwahl / Installierung
Geeigneten Platz für den Abschäumer an der
Glasscheibe vorbereiten, die innere Glasscheibe
sollte algenfrei sein, die Außenseite sollte trocken
und sauber sein.
Comline
®
DOC Skimmer 9012 / 9012 DC in
eine Ecke des Aquariums so aufstellen, dass er
leicht bedienbar ist (1), der Schaumtopf muss gut
zugänglich sein.
Über dem Abschäumer soll genügend freier Raum
vorhanden sein, um den Abschäumertopf senkrecht,
ohne an den Rahmen oder die Leuchte anzustoßen,
entnehmen zu können (2). Dies ist erforderlich,
da ein Teil des Schaumreaktors am Schaumtopf
verbunden ist.
Der Wasserstand im Aquarium sollte mit der
Oberflächenabsaugung übereinstimmen (3), siehe
Inbetriebnahme / Wasserstand. Wir empfehlen
dafür eine Wasserstandsregelung durch TUNZE
®
Osmolator
®
.
Anfängliche Laufgeräusche der Pumpe verringern
sich nach ein bis zwei Wochen Einlaufzeit.
Placement / Installation
Préparez l’emplacement de l’écumeur sur la vitre de
l’aquarium, la surface interne de l’aquarium doit être
libre d’algues, la surface externe sèche et propre.
Installez Comline
®
DOC Skimmer 9012 / 9012 DC
dans un coin de l’aquarium et de manière à ce qu’il
soit facile d’utilisation (1), le godet d’écumage doit
être bien accessible.
L’espace libre au-dessus de l’écumeur doit être
suffisant afin de pouvoir retirer verticalement et
facilement le godet sans toucher l’éclairage ou la
galerie (2). Ceci est important car le godet et le
réacteur d’écumage ne forment qu’une seule pièce.
Le niveau d’eau de l’aquarium doit correspondre à
la grille d’aspiration de l’écumeur (3), voir Niveau
d’immersion / Mise en service. Nous conseillons
l’utilisation d’une régulation de niveau par
Osmolator
®
TUNZE
®
.
Les bruits de pompe à la mise en service se
réduisent très sensiblement après une à deux
semaines de fonctionnement.
Position selection / installation
Prepare a suitable place on the glass pane, whereas
the inner glass pane should be free of algae, and
outside should be clean and dry.
Place the Comline
®
DOC Skimmer 9012 / 9012
DC into a corner of the aquarium so that it can be
easily operated (1), and the skimmer cup is properly
accessible.
There must be enough clearance above the
skimmer, to be able to remove the skimmer cup
vertically without hitting the frame or the lamp (2).
This is necessary because part of the foam reactor
is connected to the skimmer cup.
The water level in the aquarium should coincide
with the surface suction device (3), please refer
to „Commissioning / Water level“. For this, we
recommend performing the water level control with
the TUNZE
®
Osmolator
®
.
Initial running noises of the pump will be reduced
after a one or two week break-in period.