42
43
Foamer von der Schäumerplatte entfernen (5).
Luftschlauch von dem Foamer abziehen (6).
Wartung des Foamers vornehmen, siehe Comline
®
Foamer 9012.040 / 9012.041 Wartung.
Der Luftweg muss vom Schalldämpfer bis zum
Foamer frei und sauber sein. Lufteingang am
Foamer (7) gut kontrollieren ggf. reinigen.
Untere Lochplatte reinigen - es können sich
Ablagerungen ansammeln.
Gehäuse gründlich ausspülen und ggf. Algen
entfernen.
Nach Beendigung der Wartung, die verschiedenen
Komponenten rückwärtig wieder zusammensetzen.
Gehäuse und Blende senkrecht auf eine gerade
Fläche stellen (8) und zusammenschieben oder
waagerecht auf den Tisch legen und oben drauf
drücken (9). Kabeldurchgang gut beachten! Der
Silikonschlauch darf im Abschäumer nicht geknickt
sein!
Wichtiger Hinweis: Untere Lochplatte in die vorletzte
Schiene schieben. Die untere Schiene muss frei
bleiben!
Remove the Foamer from the skimmer plate (5).
Disconnect air hose from the Foamer (6).
Perform a maintenance of the Foamer, see Comline
®
Foamer 9012.040 / 9012.041 maintenance.
The air path must be clean and free all the way from
the silencer to the Foamer. Thoroughly check the air
inlet on the Foamer (7) and clean if necessary.
The perforated bottom plate should be cleaned -
there might be a cummulation of sediments.
Thoroughly rinse the housing and remove any algae.
After the maintenance is concluded reassemble the
various components in reverse of the disassembly
order. Place the housing and panel vertically onto
a flat surface (8) and slide them together, or place
them onto a table horizontally and apply pressure
from above (9). Observe the cables routes! The
silicone hose in the skimmer must not be kinked!
Important note: Insert the perforated bottom plate
into the penultimate rail. The bottom rail has to
remain unloaded.
Retirez le Foamer de la plaque interne (5).
Retirez le tuyau d’air du Foamer (6).
Effectuez l’entretien du Foamer, voir Comline
®
Foamer 9012.040 / 9012.041 Entretien.
Le circuit d’air doit être propre et non obstrué depuis
le silencieux jusqu’au Foamer. Bien contrôler et
nettoyer l’entrée d’air (7) du Foamer.
Nettoyer la plaque percée inférieure, des dépôts
pourraient s‘accumuler.
Nettoyez le corps de l’écumeur, éliminez les algues
et les dépôts éventuels.
A la fin de l’entretien, remontez à nouveau
les différentes parties dans l’ordre inverse du
démontage. Posez le corps Comline
®
et la plaque
avant de l’écumeur avec Foamer sur une surface
parfaitement plane (8) en les réunissant avec une
légère pression ou posez le tout à l’horizontal sur une
table et pressez fortement sur le dessus (9). Tenir
compte du câble d’alimentation! Dans l’écumeur, le
tuyau silicone ne doit pas être plié!
Remarque importante: La plaque percée inférieure
doit être introduite dans l‘avant dernière position du
corps, la dernière position doit rester libre!