TÜNKERS TMI8 V2.1, Руководство по эксплуатации

Страница: 9 / 12

Tünkers 8-Channel Motor Terminal
for controlling maximum 8 electronic clamping devices
TMI8 V2.1
Subject to technical alterations Page -9- 06/03/2018
TÜNKERS ®
Maschinenbau GmbH Am Rosenkothen 8 • D-40880 Ratingen Tel. 02102 4517-0 • Fax 02102 445808 Internet www.tuenkers.de
Command diagram automatic mode for a separate clamp
5.2 Manual mode
The control unit of the 8 clamps can also be carried out manually. For
this purpose, the control unit must be switched from automatic mode to
manual mode. This is carried out via the connection of the KEBA termi-
nal on socket XS4. After inserting the hand-held terminal, the
operating display initially stays open.
On the KEBA terminal, now the current status of the TMI8 in
automatic mode is displayed. If the menu selection is selected
in the KEBA terminal, the TMI8 changes to manual mode
When returning to the status display on the KEBA terminal, the TMI8 is
switched back into the automatic mode.
For further details of manual operation using the KEBA terminal, see
documentation DB KEBA TMI8 V2.XX.
AA
HH
1 command „open“ 1
1 command „open“ 1
1 command „close“ 1 1 command „close“ 1
feedback „close“ feedback „close“
feedback „open“
Clamp is closed →
command open →
Clamp opens
command is only
accepted if previously
reset
Clamp is open →
remove command
open
→
Clamp stopped
Clamp is open →
command close →
Clamp closes
order is only accepted
if previously reset
Clamp is closed →
remove command
close
→
Clamp stopped
Clamp is closed →
command open →
Clamp opens
additional command close →
Clamp stopped →
no error output
new commands will only be
accepted if they were reset
previously