Tufline MVT1710, Руководство оператора, Страница: 46 / 50

Optional Equipment Cont’d
Center Sweep Kit
Figure 11
MVT1710, MVT1712,
MVT1713, MVT1715
Part Number 11476MVT
Ref.# Part # Description Qty.
1 10388 SHANK BRACKET 4” BEAM 1
2 9175 SHANK HOLDER 4” BEAM 1
3 10602 BALK BREAKER SHANK 1
4 9192 HEX BOLT, 5/8” X 2 1/2”, GR. 5 1
5 T-22 HEX NUT, 5/8” 7
6 T-24 LOCK WASHER, 5/8” 7
7 T-746 HEX BOLT, 5/8” X 5 1/2” 6
8 13614 4” SWEEP POINT 1
9 14984 PLOW BOLT, 7/16” X 1 1/2” 2
10 14986 HEX NUT, 7/16” 2
11 14987 LOCK WASHER, 7/16” 2
12 14985 FLAT WASHER, 7/16” 2
13 9354 FLAT WASHER, 5/8” 1
Optional Equipment 43
Center Sweep Kit Mounting Instructions
Reference Figure 11
To attach balk breaker to disk, remove the two
top bolts from Ref. #1 (shank bracket) and slide
on to center tube of frame, between the wheel
carriage and depth control bracket. Insert top
bolts back in Ref. #1 and apply lock washer and
hex nut. DO NOT TIGHTEN! Attach Ref. #3
(balk breaker shank) to Ref. #2 (shank holder)
with hardware supplied, then tighten this bolt
only. Ref. #2 can be adjusted for different
depths. Normal operational depth is the same
as the disk blade depth. Depth adjustments can
be made by putting disk on the ground, and
adjusting bolts in Ref. #2 up or down. Once
depth has been set, tighten all bolts and balk
breaker is ready for operation.Please see Bolt
Torque Chart (Page 45) for proper torque infor-
mation.
*NOTE- Retighten all fasteners after first opera-
tional use.Please see Bolt Torque Chart (Page
45) for proper torque information.