18
12.3. Card Storage Capacity
The size of the memory card supplied by TTi may vary from time to time, but will be in the range 512MB
to 2GB.
The size if the files stored by PSAnalyzer are very small in comparison. Set-up files are a few hundred
bytes each, trace files are around six kilobytes each, and screen bitmap files are 120 kilobytes each.
Note, however, that the FAT16 format of the card creates a minimum file allocation size of 16 kilobytes
(or possibly greater) for any file stored.
13.
Removing and Re-fitting the Palm T|X
All of the functionality of the Palm T
|
X is available when it is mounted within the PSA1301/2701 spectrum
analyzer. However, users may wish to remove it in order to carry it in their pocket as a personal
organiser or to use for other purposes. Removing and re-fitting is quick and simple.
Removing
Re-fitting
Remove the Stylus from the Palm T
|
X. Push the Palm T
|
X onto the connector by pushing it firmly in the
line of the instrument.
Ensure that the two fixing latches are open. Locate the top cover onto the rear of the instrument and
lower it down, then operate the two fixing latches to secure it. Refit the Stylus.
Preventing Unauthorised Removal
In circumstances where removal of the Palm T
|
X is regarded as undesirable, the top cover can be
secured using screws which fit underneath the two latches. TTi provides Torx head screws for this
purpose (M2.5 size) although they are not fitted.
Lift the two latches close to the top
of the unit and remove the silver
top cover (see drawing). Remove
the Palm T|X by gripping its sides
and pulling it towards the top edge
of the spectrum analyzer. (Note
that the connector is a tight fit and
that a hard pull may be needed).
Note: the top cover could be
secured by screws under the
latches which must be removed
first (see section Preventing
Unauthorised Removal below).