SPECIFICATIONS
INSTALLATION
THIS EQUIPMENT MUST BE INSTALLED BY AN
AUTHORIZED PERSON IN ACCORDANCE WITH AS 5601,
LOCAL AUTHORITY, GAS, ELECTRICITY, ANY APPLICABLE
STATUTORY REGULATIONS AND MANUFACTURER
REQUIREMENTS.
NOTE: INSTALLATION IS THE RESPONSIBILITY OF THE OWNER
Gas Inlet Connection:
½” BSP Female.
Gas Connection Point:
The gas connection point is located at the rear of
the unit (300 mm from the right hand side and
45mm above the base of the unit)
Details are shown in the drawing at the rear of this
manual.
Gas Connection:
The appliance must be connected by an
authorized person to the gas type specified on the
unit. The gas type is shown adjacent to the gas
connection point and on the data plate.
Connect
to and use only the correct type of gas.
The authorized person installing this equipment
must comply with AS 5601 requirements.
Prescribed requirements include, commission the
equipment, gas leakage testing, operational
checking and adjustments.
All units are tested and adjusted at the factory; however, burners and pilots
must be checked at the installed location and adjusted if necessary.
Salamander Manual
Page 7
Revision: 13 Sep 07
OPERATOR MANUAL S86 130907.doc
