Triumph Adler P-C3570DN, Руководство пользователя

Страница: 219 / 255

6-4 Troubleshooting
Black or white vertical streaks Refresh drum.
Perform the following procedures on the operation panel and try cleaning
the drum surface using the printer's built-in cleaning system.
1 In the mode selection menu, press [

] or [

] to select
Adjust/
Maint.
.
2 Press [OK] .
Adjust/Maint.
menu screen appears.
3 Press [

] or [

] to select
Service Setting
.
4 Press [OK] . The
Service Setting
menu screen appears.
5 Press [

] or [

] to select
Drum
.
6 Press [OK] . A drum cleaning confirmation message is displayed.
7 Press
[Yes]
( [Left Select] ). Drum cleaning begins. When drum
cleaning ends, the
Service Setting
menu reappears.
Clean the LSU.
For details, refer to
LSU (LSU cleaning mode setting) on page 4-130 .
Faint or blurred printing Refresh drum.
For details, refer to
Drum (Drum/Refresh mode setting) on page 4-130 .
Make sure the paper type setting is correct the paper being used.
For details, refer to
Paper Settings on page 4-41 .
Conduct color calibration either by switching the printer off then on or using
the printer operation panel.
For details, refer to
ColorCalibration on page 4-119 .
Try adjusting the color control settings using the printer driver.
Check the operation panel. If the Toner is low.(Replace when
empty.) message is displayed, install a new toner kit. To replace toner,
refer to Toner Container Replacement on page 5-2.
Grey background Conduct color calibration either by switching the printer off then on or using
the printer operation panel.
For details, refer to
ColorCalibration on page 4-119 .
Dirt on the top edge or back of the paper Check the paper chute and the ramp.
Pull out the paper transfer unit and check for toner on the paper ramp.
Clean the paper ramp using a soft, dry, lint-free cloth. For details, refer to
Cleaning the Paper Transfer Unit on page 5-8 .
Printed Results Corrective Action
Direction
of Paper
Feed