Triumph Adler CLP3316, Руководство по обслуживанию

Страница: 48 / 188

2HJ/2JK
1-3-16
Purpose
To reset the life counter for the developer units and drum units included in maintenance kit.
Procedure for replacing the maintenance kit
1. Remove the four old drum units (See page 1-5-13).
2. Remove the LED print head from each old drum unit and then refit to the new drum
unit (See page 1-5-15).
3. Install the four new drum units.
4. Replace the four developer units (See page 1-5-12).
5. Replace the fuser unit (See page 1-5-32).
6. Replace the paper feed unit (See page 1-5-6).
7. Replace the primary transfer unit (See page 1-5-22).
8. Replace the primary transfer cleaning unit (See page 1-5-24).
9. Replace the two ozone filters (See page 1-5-51).
10. Replace the retard roller (See page 1-5-8).
11. Replace the MP tray feed roller (See page 1-5-11).
Procedure
Enter the service mode [>>Maintenance].
1. Press the OK key. Message [>>Maintenance?] is displayed.
2. Press the OK key twice. The counter for each component is reset immediately.
Completion
NOTE: Occurrences of resetting the maintenance kits are recorded on the service status
page and event log in number of pages or images at which the maintenance kit was
replaced (See page 1-3-2 and 1-3-9). This may be used to determine the possibility that the
counter was erroneously or unintentionally reset.
Developer refreshing
Description
The laser output of the image data for developer refreshing is carried out, and operation to
exposure, developing, and primary transfer is performed by 10 pages. (Paper is not fed)
Purpose
To perform when occurring the decrease of image density or the developing problem.
Procedure
1. Enter the service mode [>>DEV-CLN].
2. Press the OK key. Message [>>DEV-CLN?] will be displayed.
3. Press the OK key. Developer refreshing will be started.
Completion
Figure 1-3-8Developer refreshing Image data
Service items Description
>>DEV-CLN
A4 paper size
200 mm
33 mm
Toner image on the
primary transfer belt