Installation and user guide- 4
3 Quick Start Guide
INSTALLATION
•
Insert the batteries in your fall detector. (cf. §5.1)
•
Position the rigid tube.
•
Put in place your detection device on the edge of your pool at the proper place being careful
about the immersion depth of the tube: 8,5 in (+/- 1 in). Cut the rigid tube at the proper length
if necessary. (cf. §5.2)
•
Perform a fall test : Simulate somebody falling into the pool by dropping a 2.5 US gallons jerry
can full of water (in order to weight 18 lbs) off the edge of the pool – the siren must sound a
maximum of 20 seconds after the fall. (cf. §5.3)
•
Stop the siren by entering your password (Initially 1234).
•
Wait for the reset of the product in “ALARM” mode during 20mn max. (The
LED starts to
blink in green).
•
Immobilize the TRITON
TM
alongside the edge of the pool with the supplied fixation kit. Your
device is now operational. (cf. §5.4)
UTILISATION
All the LED indicate independent states.
SIGNAGE
ACTIVATION CODE
IDENTIFICATION
LED
:
(blinks in green quickly)
One high tone sound: PIP
11 or 22 or 33 or 44
(A double hit on any key)
« DETECTION » mode
LED
:
(blinks in red quickly)
One low tone sound: BURP
1234
(or the password you entered)
« INACTIVE DETECTION » mode
LED
:
(still)
122344
1111
« PASSWORDCHANGE» mode
(manual mode code followed by
password change)
LED
:
(blinks once in green)
One high tone sound: PIP
Any good entry
GOOD ENTRY
LED
:
(blinks once in yellow)
One low tone sound: BURP
Any wrong entry
BAD ENTRY
LED
:
(blinks in red quickly)
One low tone sound: BURP
(Once every minute)
None
“LOW BATTERIES” mode
Please replace the batteries as soon as
possible
