Installation and user guide- 15
7 TRITON™ Operating principle
PRÉCAUTIONS D’UTILISATION
•
TRITON™ can NOT be a substitute for parents’ watchfulness and/or responsible grown-
ups, which remain the most reliable method of 5- years old children safety.
•
The intervention of a responsible grown-up is mandatory while the alarm rings out.
•
A few unfavorable meteorological conditions (strong wind, storms …) plus the use of a few
powerful cleaning tools could cause inopportune triggers.
•
Your alarm system is inoperative if the water in the probe is frozen or if the swimming pool
surface is frozen. It is hard to know when the water starts to freeze in the pipe. In case of
doubt, please check the proper operating state of your falling detector.
•
For the external cleaning of your device, please avoid using high pressure unit, abrasive
brush and/or any tool that can stripe or impair your falling detector.
•
The proper performance of TRITON™ is not correctly achieved if used in parallel with
tarpaulins.
•
To guarantee the good operating state of your device, please maintain the water clear and
clean. (Notably, to avoid the formation of algae in the probe).
•
In case of restart of your falling detector after an extended stop, please proceed the tests
explained in § 5.4. In case of issue, please contact immediately your local seller.
•
Regarding the maintenance of the device after the first installation, only replacing the
batteries is allowed.
•
Check regularly, the proper performance of your falling detector by running monthly control
tests appearing at the end of this manual. (See §11).
•
A few cleaning robots (for instance “diving” ones) are incompatible with falling detector
systems.
•
The person setting up the device should be aware that another person should monitor the
pool.
•
A person’s watchfulness and/or a responsible grown-up are necessary between the end of
the swim and the automatic reset of the alarm system.
7.1 I want to swim
-
Your falling detector watches out (i.e. : « DETECTION » mode activated (The LED
:
blinks
in green)
-
Type your password (initially 1234). (Inactive detection mode activated: The LED
:
blinks in red and a low tone sound (BURP) is heard)
-
You can swim.
After the swim, the pool won’t be monitored until the automatic reset which will occur while the pool is
quiet. Typically, the reset occurs after 10 mn approximately.
D
URING THIS PERIOD
,
A RESPONSIBLE ADULT
/
GROWN UP
MUST
KEEP WATCHING OVER THE POOL
.
