Installation and user guide- 12
-
Contact your local reseller
-
Contact our technical support :
All those tests have been validated; you can proceed the final installation of your device.
5.5 Final installation
Remove the rigid tube a few centimeters to free the cover.
IMAGE 1
-
Remove the cover of your falling detector.
-
Locate the 3 holes deep down the base.
-
Place the base on the brink in order for the rigid tube to be at more than 5mm from the edge.
IMAGE 2
-
Using something like a fibre tip pen, make 3 dots through the 3 holes to locate them and drill them
in your brink.
-
Remove the base from the brink.
IMAGE 3
-
Drill the 3 holes with the Ø 0.3 drill and put in the tapping inserts.
IMAGE 4 et 5
-
Position the 3 white stabilization foams under the base in their designed locations.
IMAGE 6
-
Locate and settle the base with the 3 washers and screws (the 3 washers should be installed inside
the case).
IMAGE 7
-
Put in place the 4 little black joints on the base and screw securely.
IMAGE 8
WARNING: The joints and foams installation should, like the fixation, be performed with care to
guarantee the waterproofness and the good operating state of your device.
-
Check that the 2 main black joints are correctly positioned in their location on the base.
-
Put back in place the cover and screw down the 4 screws. (Don’t use an electric screwdriver).
-
Put in place the 4 protection caps. .
IMAGE 9
-
Put back the rigid tube and screw-down the small screw.
IMAGE 10
-
Check one more time the good operating state of the device:
- Switch on “INACTIVE DETECTION” mode by typing the password (initially 1234).
(The LED
:
blinks in red and you’ll hear a BURP)
o
Wait for the automatic reset (The LED
:
blinks back in green)
o
Make a fall test from the furthest point
o
If the fall is detected within 20 seconds, your installation is complete.
-
Wait for the automatic reset of the TRITON™ before leaving the pool side.
-
Fill in the validation test form and send it to the following address :
TRITON™ Customer Care
SafeBlue
c/o Gestrust, 2 rue Thalberg
Case postale 1507
1211 Geneve 1 - Switzerland
IMAGE 1 : Tube retiré de 2 à 3 cm avec main
IMAGE 2 : Illustrer les 5mm
IMAGE 3 : Repère position trous margelles
IMAGE 4 : Perçage margelle
IMAGE 5 : MEP chevilles
IMAGE 6 : Mise en place mousses
IMAGE 7 : Fixation base sur margelle
IMAGE 8 : MEP petit joints
IMAGE 9 : MEP capuchons
IMAGE 10 : Fixation vis sur tube coudé
