Installation and user guide- 16
7.2 Automatic reset
-
Your falling detector keeps on checking the agitation state of the pool. As soon as the pool is
sufficiently quiet, after a swim or a strong perturbation (strong wind, upriver swimming system …)
your falling detector switches automatically to REACTIVATION mode (the LED
:
blinks in green / red). The fall detector is active but downgraded.
-
As soon as the pool is fully quiet, your falling detector switches automatically to “DETECTION”
mode(the LED
:
blinks in green). This could take more than 10 minutes.
Your pool is now secured.
WARNING: It is possible that the device changes to DETECTION mode if you are in the pool
without making any disturbances.
7.3 Manual reset
After a swim, you can signal to your falling detector that your pool is let unused, in order for it to
restart the monitoring faster.
You are in one of the 3 cases below:
Commoved pool:
Cas
e
1
Lightly commoved pool: Case 2
Quiet pool:
Cas
e
3
Press twice on any key while leaving the pool.
Case 1: Your falling detector measures that your pool is too commoved. In that case, your device
understands your request by responding with a high tone sound (PIP) but can’t restart immediately
the monitoring. The LED
:
blinks in red. It will progressively start the monitoring as the
pool becomes quiet.
D
URING THIS PERIOD
,
A RESPONSIBLE ADULT
/
GROWN UP
MUST
KEEP WATCHING OVER THE POOL
.
Case 2: Your falling detector measures that your pool is lightly commoved. In that case, your device
understands your request by responding with a high tone sound (PIP) and restarts monitoring but
can’t guarantee the detection of a 8kg fall. The LED
:
blinks once in red followed by a
green blink and so on. It will progressively start the monitoring as the pool becomes quiet.
D
URING THIS PERIOD
,
A RESPONSIBLE ADULT
/
GROWN UP
MUST
KEEP WATCHING OVER THE POOL
.
Case 3: Your falling detector considers that your pool is quiet. It restarts the monitoring by switching
the LED
:
in green and validating the choice with a high tone sound (pip).
Y
OUR POOL IS SECURED
.
7.4 Too much wind
In some cases, while the meteorological conditions are too unfavorable (strong wind, heavy
rain, thunderstorms …), your falling detector is susceptible to stop its monitoring. The LED
:
blinks in red.
D
URING THESE BAD CONDITIONS
,
YOU SHOULD
IMPERATIVELY
INCREASE YOUR WATCHFULNESS
