Triton ELINA, Инструкция по установке и эксплуатации

Страница: 9 / 24

Thermostatic bar mixer shower
7
MAKING GOOD
Make good the wall and complete the tiling.
NOTE: It is advised to use a suitable sealer
around the variable connector where it enters
the wall to stop water ingress
(fig.6) .
Screw the supplied cover trims onto the fittings
until tight to the wall
(fig.6) .
PUSH FIT BRACKET
If the product has been supplied with the push
fit bracket
(fig.6a), please follow the fitting
instructions supplied with it.
FLOW REGULATION
IMPORTANT: Make sure that all supply
pipework has been flushed through before
fitting the mixer and flow regulators.
A flow regulator is supplied for use with high-
pressure water systems and may be fitted with
any of the systems listed to reduce flow rate and
assist economy.
If required, fit the flow regulator into the outlet
of the mixer shower as shown in
fig.7.
Fig.6
Seal around
the connectors
Fig.7
Flow
regulator
Note:
the flow regulator
must
be fitted as shown.
Push in, in this
direction.
Note: the flow
regulator
must be
pushed fully
down into the
shower outlet.
Fig.6a