4
Assembly
Prior to assembly, lay out all components and hardware as listed in the
Parts List
section.
1
Slide the Control Box
G
off the Frame End Assembly and set aside. Fully separate Frame End
D
from Frame End (Control Box)
C
.
You will find the Center Rails
E
inside.
2
Place one of the Legs
A
into the Frame End (Control Box)
C
ensuring the bar (arrow) is on “top” in relation to the Leg. Line up the
holes on the Leg with the holes on the Frame End (Control Box).
Using the supplied 4 mm Hex Key, insert four (4) M6 x 10 Machine Screws
K
through the holes in the Frame End (Control Box) and
tighten to secure.
G
D
D
C
C
E
K
K
A
C
3
Slide the Side Bracket
F
into the Frame End (Control Box)
C
. Under the Frame End/Leg Assembly, insert two (2) M6 x 14 Screws
L
.
Using the supplied 4 mm Hex Key, tighten screws to secure.
Note:
For this step, the Frame End (Control Box) should be placed on the side of the desk where you plan to mount the Control Box and Handset.
F
C
L
Repeat this step for the other Frame Leg/End Assembly.
Repeat this step for the other Leg and Frame End
D
.
