10
Troubleshooting
The desk is not functioning properly.
It may need to be reset. Follow the Resetting the Handset procedure outlined in the
Operation
section.
The Handset LED displays “RST” (reset).
Follow the Resetting the Handset procedure outlined in the
Operation
section.
The Handset LED displays one of the following error codes:
Error Code
Error summary
Error Code
Error summary
E01
M1 overcurrent protection
E08
M2 hall error
E02
M2 overcurrent protection
E09
M3 hall error
E03
M3 overcurrent protection
E10
M4 hall error
E04
M4 overcurrent protection
E11
M5 hall error
E05
M5 overcurrent protection
E12
M6 hall error
E06
M6 overcurrent protection
E13
Communication interrupt between controller A and B
E07
M1 hall error
H01
Overheat protection / Duty cycle protection
To clear the error code, perform the Resetting the Handset procedure outlined in the
Operation
section. If the error message persists after a
reset procedure attempt, contact Tripp Lite support.
The Handset readout displays “HOT”.
Allow the base to cool down for 20 minutes.
Specifications
Height Range
23.5” to 49” (Without Desk Top)
Desk Base Width
42.5” minimum to 72” maximum
Travel Speed
1.5” per second (No Load)
Load Capacity
220 lbs. @ 20,000 cycles
Duty Cycle
10%. Max. 2 minutes on 18 minutes off
Certifications
Tested to UL 508, UL 1004-7, UL 1004-1, CSA C22.2.14-10, CSA C22.2.100-04, CSA 22.2.77-95
Compliance
ANSI/BIFMA X5.5-2014 for Office and Institutional Furnishings
