www.trikdis.com
13
September 2021
FLEXi SP3 user manual
8
Control using phone calls
Note:
If at least one zone is violated, it will not be possible to arm the alarm system (if the
FORCE
property is not
assigned to the violated zones).
When controlling the alarm using phone calls, only
ARM
and
STAY
security modes are available.
Before calling, it is recommended to check the current security mode by sending a partition state request
via SMS message (command:
ASKA 123456
), and also check the current zone states by sending a zone
state request via SMS message (command:
ASKI 123456
).
Programming the control panel allows to enter user phone numbers and specify what these users can control using phone
calls: arm/disarm the alarm or control electronic equipment connected to the module’s
PGMx
output.
Call the number of the SIM card inserted into the
FLEXi SP3
security control module. If the phone number you are calling from
is specified in the module‘s memory, the control panel will answer the call and you will have to enter the control command
(see control command table).
List of commands that can be entered via phone keypad
Keypad buttons
Function
Description
[1][partition no][#]
Arm selected alarm
system partition
E.g. (arm partition 2):
12#
[2][ partition no][#]
Disarm selected alarm
system partition
E.g. (disarm partition 2):
22#
[3][output no][#][state no]
Control selected output
OUT
Controls a specified output OUT.
State:
[0]
– output turned off;
[1]
– output turned on;
[2]
– turned off for pulse time;
[3]
– turned on for pulse time;
(pulse time is specified using
TrikdisConfig
software, in
the PGM table)
E.g. (set output 1OUT to “on” state):
31#1
E.g. (set output 2OUT to “on” state for
Pulse time
specified in the
TrikdisConfig
“PGM” table):
32#3
If the
Re-ARM
function is activated, if the
Delay
zone is not violated after the set entry time passes from the moment of the
alarm disarm command, the alarm system will automatically return to the previous security mode.
9
Control using SMS messages
Using SMS messages, you can control the
FLEXI SP3
security control panel and change some of the panel‘s parameters. Only
TrikdisConfig
software can change all parameters of the module.
Structure of an SMS message: Command
space
Password
space
Data
For a control panel with default settings, the SMS password is
123456
. For safety reasons, we recommend changing it to a
combination only you know and not forgetting it!
SMS command list
Command
Data
Description
INFO
Request information about the control panel. Object name, partition state, IMEI
number, GSM signal strength, firmware version and serial number will be included
in the reply. E. g.:
INFO 123456
RESET
Reset the device. E.g.:
RESET 123456
OUTPUTx
ON
Turn on an output, “x” is the output number. E.g.:
OUTPUT1 123456 ON
