Triax HMX 442 LP4K, Руководство пользователя

Страница: 32 / 52

User Manual
32 /52
31
Command Function Feedback Example
System Commands
/*Type; Enquires models information. “Triax Model”
/%Lock; Locks the front panel buttons on the Matrix. System Locked!
/%Unlock;
Unlocks the front panel buttons on the
Matrix.
System Unlock!
/^Version; Displays Firmware version VX.X.X
/:Message Off;
Turn off the feedback command from the
com port. It will only show simple words
like “SWITCH OK!”.
/:Message Off;
4.3.4 RS232 Communication Commands (HMX 663LP4K & HMX 884LP4K)
Baud rate: 9600 Data bit: 8 Stop bit: 1 Parity bit: none
Command Function Feedback Example
/:MessageOn;
Turn on the feedback command from the
com port.
/:MessageOn;
Demo.
Switch to the “demo” mode, convert input
and output in turn like1B1, 1B2, …8B7,
8B8, 1B1… and so on .The switching
interval is 2 seconds.
Demo Mode
Undo. To cancel the previous operation. Undo Ok!
Operation Commands
[x]All.
Transfer signals from the input channel [x]
to all output channels
X To All. (X=1~8)
All#.
Transfer all input signals to the
corresponding output channels
respectively like 1->1, 2->2…
All Through.
All$. Switch off all the output channels. All Closed.
[x]#.
Transfer signals from the input channel [x]
to the output channel [x].
X Through. (X=1~8)
[x]$. Switch “OFF” the output channel [x]. X Closed. (X=1~8)
[x]@. Switch “ON” the output channel [x]. X Open. (X=1~8)
All@. Switch “ON” all output channels. All Open.
[x1]V[x2].
Transfer the AV signal from the input
channel [x1] to the output channel [x2]. AV: X1-> X2 (X1/
X2=1~8)
[x1]B[x2].
Transfer the AV and IR signal from the
input channel [x1] to the output channel
[x2].
AV: X1-> X2 (X1/
X2=1~8)
Status[x].
Check the I/O connection status of output
[x]
AV: Y-> X (X=1~8,
Y=1~8)
Status.
Enquire the input channel to the out-
put channels one by one. This example
shows the 8x8.
AV: 1-> X1
AV: 2-> X2
AV: 3-> X3
AV: 4-> X4
AV: 5-> X5
AV: 6-> X6
AV: 7-> X7
AV: 8-> X8
Save[Y].
Save the present operation to the preset
command [Y], ranges from 0 to 9. Save To FY (Y=0
-9)
Recall[Y]. Recall the preset command [Y].
Recall From FY
(Y=0-9)