Trek 2021 E-CALIBER, Дополнение к руководству по обслуживанию

Страница: 5 / 22

2021 E-Caliber Service Manual
4
Rear triangle and chainstay bridge
1
3
2
4
4
5
Item Description
Quantity in
Assembly Part Number Torque (Nm)
1 Rear IsoStrut axle 1 591626 10
2 End cap bolt 1 —
3 Front IsoStrut bolt and washer 2 W584485 5
4 Chainstay bridge bolt 4 5265697 8
5 Chainstay bridge, charcoal colour 1 5266755 —
Tools
• Bike repair stand
• Torque wrench with 6 mm hex bit, T25 and T30
Torx bits
• Grease
Important: You must have the main pivot bearing and
sleeve (See the Main pivot section on page 6 ) and the
IsoStrut (See the IsoStrut section on page 10 ) installed
on the rear triangle before attaching the rear triangle to
the frame.
1. Put the seat post into a bike repair stand.
2. Fit the rear triangle into the main frame.
3. Install the two front IsoStrut bolts and washers (3).
Important: Do not torque the bolts at this time.
4. Apply grease to the IsoStrut rear axle (1).
5. Install the IsoStrut rear axle (1) and end cap bolt (2).
Important: Do not torque the bolts at this time.
6. Apply grease to the flat surfaces of the chainstay
bridge (5).