Trek 2021 E-CALIBER, Дополнение к руководству по обслуживанию, Страница: 14 / 22

2021 E-Caliber Service Manual
13
Air volume spacer (continued)
Tighten the lock ring
1. Add Loctite Blue 243 threadlocker or similar to
a minimum of two threads, covering 60-90°of
threads.
2. Stand behind the seat and pull the seat up to extend
the suspension. This will bring the lock ring in contact
with the strut.
3. Use the BSA30 wrench to turn the lock ring onto the
strut.
Tip: For the best results, sit on the rear tyre for this
step to balance the bike.
4. As you tighten the lock ring, orientate the upper air
cap as shown below.
Size small frame: the air fill valve aligns with the
mounting tab.
Size medium, large and extra large frames: the
cable hanger aligns with the mounting tab.
5. Place the torque wrench in the hole in the BSA30
wrench. Torque the lock ring to 17 Nm.
6. Verify that the shock is positioned to accept a shock
pump to the air valve. If there is interference, reposi -
tion the shock.
7. Install the washers and bolts at the front of the
shock. Torque the bolts to 5 Nm.
8. Torque the rear shock axle to 10 Nm.
9. Use the shock pump to re-inflate the shock air pres
-
sure to the PSI noted prior to beginning the air spacer
procedure.
10. Perform the sag procedure to determine the proper
rider setting for the strut.