2021 E-Caliber Service Manual
18
Carriage wiper seals and bushings (continued)
Install the IsoStrut into the carriage
1. Remove the compression sleeve.
2. Carefully pull out the oil plug from the shock.
3.
Place the foam blocks into the carriage and position
them against the sides of the carriage. Do not soak
the foam blocks in fork bath oil prior to installation.
4. Lightly oil the inside of the carriage seals.
5.
With the sag o-ring in place on the shock, insert the
shock into the carriage.
Install the damper body hardware
See
.
Add oil to the carriage
1. Use a syringe to fill the IsoStrut with 15 cc of 10 wt
oil.
2.
Firmly press the
oil plug back into the
aft
end of the
shock. Make sure that the plug is tightly seated in the
opening.
3.
Install the compression sleeve
into the oil plug.
4. Install the IsoStrut rear axle and end cap nut. Torque
the axle to 10 Nm.
Tip:
If the compression sleeve will not allow the rear
IsoStrut hardware to pass through, the oil plug is not
fully seated into the shock. (See step 2.)
5. Install the front IsoStrut washers and bolts. Torque
the bolts to 5 Nm.
6. Wipe off any excess oil from the IsoStrut.
Содержание 2021 E-CALIBER
Страница 1: ...2021 E CALIBER SERVICE MANUAL SUPPLEMENT...