Trek 2021 E-CALIBER, Дополнение к руководству по обслуживанию

Страница: 16 / 22

2021 E-Caliber Service Manual
15
Carriage wiper seals and bushings (continued)
Remove the carriage seals
1. Use the Delrin rod to pull out the front seal.
Tip: You may need to move the rod around the car-
riage to remove the seal.
2. Pull out the foam ring. This is the only foam ring in the
carriage.
3. Use the Delrin rod to pull out the rear seal.
If you are replacing only the seals, jump to Carriage wiper
seals and bushings (continued) section on page 17 .
If you are replacing both the seals and the bushings, con-
tinue with the Replace the bushings section on page 15 .
Replace the bushings
NOTICE:
Do not apply grease to the bushings.
1. Put the slide hammer with the collet attached inside
the front end of the carriage.
NOTICE: Take care to engage only the bushing,
and NOT the interior of the carriage. Engaging the
carriage could damage the carriage.
2. Thread the collet to engage the bushing lip .
Tip: Be careful not to engage the lip inside the car-
riage. Engage the bushing only.
3. Use the slide hammer to remove the bushing.
4. Repeat steps 1 to 3 to remove the rear bushing.
5.
Wipe the bushing bores with a clean, dry cloth to
remove any debris.