Pag. 7
DUALCOM-8 INSTALLATION MANUAL
ENGLISH
DUALCOM
POWER
AREA 1/2
TAMPER
FIRE
ALARM 1/2
POWER
“ON” = POWER CONNECTED
“OFF” = NO POWER CONNECTED
“FLASHING” = LOW BACK-UP BAT.
AREA 1/2
RED = AREA 1 ARMED
GREEN = AREA 2 ARMED
ORANGE = AREA 1 + 2 ARMED
TAMPER
“ON” = TAMPER ALARM TRIGGER
LED INDICATIONS
FIRE
“ON” = FIRE ALARM TRIGGER
ALARM 1/2
“RED” = AREA 1 IS TRIGGERED
“GREEN” = AREA 2 IS TRIGGERED
“ORANGE” = AREAS 1+2 ARE BOTH
TRIGGERED
Description of keypad LEDs
Fig. 5
NOTE: These indication
are necessary for fast
recognition and as a
support for those indicated
on the display.
Brief description of display programming commands
** see security level descriptions on page 12.
Command Sequence
Function
Note
[operator] [operator password ] [function]
[#]
ARM / DISARM
ARM/ DISARM OR EXIT TIME
[operator] [operator password]
[ ]
[zone to bypass] [#]
ZONE WILL BE BYPASSED
ALL ZONE MUST BE NUMBERED
WITH 2 DIGIT, FROM 01 TO 72.
EXAMPLE: FOR ZONE 4 PRESS 04
[password operator master] [*] [6] [8] [#]
GENERAL RESET - ALL ALARMS
TRIGGERED WILL STOP
ONLY LEVEL 5** OPERATOR MAY
ENTER THIS MODE
[password installer] [*] [0] [#]
USED TO ENTER INTO
PROGRAMMING MODE
ONLY INSTALLERS MAY ENTER
INTO PROGRAMMING MODE
[password operator 1] [*] [0] [#]
USED TO CHANGE THE OPERATORS
PASSWORD
ONLY LEVEL 5* OPERATOR MAY
CHANGE THE PASSWORDS.
[ ] [*] [#]
USED TO EXIT PROGRAMMING
MODE
THIS WILL FUNCTION ONLY IF YOU
ARE IN PROGRAMMING MODE
PANIC OR EMERGENCY TRIGGER
PRESS KEY FOR 3 SECONDS. THIS
WILL FUNCTION ONLY IF KEYPAD
HAS BEEN PROGRAMMED TO
ACCEPT THE COMMAND
FIRE TRIGGER
PRESS KEY FOR 3 SECONDS. THIS
WILL FUNCTION ONLY IF KEYPAD
HAS BEEN PROGRAMMED TO
ACCEPT THE COMMAND
HOLD-UP TRIGGER
PRESS THE KEY FOR 3 SECONDS.
THIS WILL FUNCTION ONLY OF THE
KEYPAD HAS BEEN PROGRAMMED
TO ACCEPT THE COMMAND
F
