Pag. 35
DUALCOM-8 INSTALLATION MANUAL
ENGLISH
10 Self learning of wireless sensor and keychain transmitters
In this section is described how you may memorize in the Dualcom-8 panel the “Pegaso” protocol
sensors. Inside of the K-8R keypad, supplied with the DUALCOM-8, is a specially made
TRANSCEIVER capable of receiving alarm trigger messages from all wireless sensors and keychain
transmitters and re-transmit these signals to the installed “Pegaso” sirens.
It is important to install this keypad in a position centrally located between all sensors in order to
increase the reception range of the R.F. transmissions.
To enter in this programming mode press the digits seen below:
On the Display will appear:
When in code learning mode you may:
1. Learn the codes of the Keychain transmitters
2. Learn the codes of all Sensor
3. Program the wireless sirens with the Dualcom-8
4. Learn and manage the remote electronic keys
10.01 To have the Dualcom-8 self learn the Peg-3 keychain transmitter
NOTE: The keychain transmitters and the electronic keys are programmed and combined with
an operator that has also a security level.
Example: By memorizing a keychain transmitter in the first position, it is automatically associated with
the operator 1 which may be then associated from level 0 to level 5 of security. If it is associated with,
for example, level 4, then the operator 1 can only Arm or Disarm the AREA number 2.
(See table on Page 12)
【
】+【
10
】+【#】
Code learning
1° Keychain trans.
Operator 1
1st Key
2° Keychain trans.
Operator 2
2nd Key
3° Keychain trans.
Operator 3
3rd Key
4° Keychain trans.
Operator 4
4th Key
5° Keychain trans.
Operator 5
5th Key
6° Keychain trans.
Operator 6
6th Key
7° Keychain trans.
Operator 7
7th Key
8° Keychain trans.
Operator 8
8th Key
Keychain TX Operator Electronic Key Security Level
Level [0 to 5]
Level [0 to 5]
Level [0 to 5]
Level [0 to 5]
Level [0 to 5]
Level [0 to 5]
Level [0 to 5]
Level [0 to 5]
F
