www.transvu.co.uk
Configuration & Operation Guide
95
E Mail
The unit can automatically transmit an e-mail to an SMTP Server under numerous conditions i.e. on
start up, on receipt of an alarm, camera failure etc. This allows the unit to be installed in unmanned
applications where a Remote Video Response Centre (or Manager etc.) would be notified by e-mail
if any of these conditions occur.
Connection Profile
It is possible for the e-mail to be transmitted via the Ethernet network or dial up
connection (PPP ‘Point to Point Protocol’). This setting presumes that a modem
has been connected or configured and the unit is connected to a LAN or WAN
and allocated a valid IP address.
Mail Server Address
This is the IP address or URL of the SMTP Server that the e-mail will be sent to.
The SMTP server will then forward this to the intended recipient.
Username
If a username is required to access the mail server, enter it here.
Password
If a password is required to access the mail server, enter it here.
Recipient Email
This is the e-mail address of the intended recipient.
Display Name (Recipient) This is the addressee name that will be shown in the email name field.
Reply to Email
This field must be configured if the recipient is to reply to an e-mail. The
unit does not accept incoming e-mails therefore ensure this is a valid e-mail
address.
Display Name (Reply To) This is the ‘reply to’ name that will be shown in the email name field.
Sender Email
These optional fields indicate the source of the e-mail notification. If the fields
are left blank the unit will use the system name to create a sender name.
Display Name (Sender)
This is the sender name that will be shown in the email name field.
Send on Startup
Select to send email notification on startup.
Send on Alarms
Select to send email notification on alarm activation.
Send on Camera Fail
Select to send email notification on camera fail.
