Trafox SUPERINTEND IM-01.IND, Инструкция по установке и эксплуатации, Страница: 37 / 50

Superintend IMD © Copyright Muuntosähkö Oy - Trafox 37
http://www.trafox.fi
performed, and a PEC-01 unit
in the PE address
XX has been
approved in the network. The
channel
CC , for which N was
approved as a reference, was
connected to the unit.
System Parameter changed [TranSize] [ N1 A]->[ N2 A]
The value of the TranSize
parameter (the primary
current of the current
transformer in load measuring,
with which the transformer
secondary current is 5 A) was
changed from
N1 to N2 .
System Parameter changed [Nom.Cur] [ N1 A]->[ N2 A]
The value of the Nom.Cur
parameter (the nominal
current of the isolation
transformer) was changed
from
N1 to N2 .
System Parameter changed [AUXalarm] [ XXX ]->[ YYY ]
The value of the AUXalarm
parameter (situations which
trigger an alarm in the AUX.
ALARM relay) was changed
from
XXX to YYY .
New Time [DD.MM.YYYY HH:MM:SS]
The new time was set:
DD=day
MM=month
YYYY=year
HH=hour
MM=minute
SS=second
System Parameter changed [AlrmDly] [ T1 s]->[ T2 s]
The value of the AlrmDly
parameter (the alarm delay in
other than isolation level
alarms) was changed from
T1
to T2 .
Debug Mode ON
The RS-485 connection
functions in the DEBUG mode
(no communication with
remote units).
Debug Mode OFF
The RS-485 connection
functions in the normal mode
(communication with remote
units functions again).
Factory Settings activated
The factory settings were
restored.
SD Card not in use
The memory card was disabled
in the settings.
System Test Failed: too low amplitude (**)
The system test detected a
measurement voltage that was
too low.
System Test Failed: too high amplitude (**)
The system test detected a
measurement voltage that was
too high.
System Test Failed: too short group delay (**)
The system test detected a
measurement delay that was
too short.