Installation and operating manual
G1035.4 – 01/2019
EN-39
7
Operation
DANGER!
Risk of crushing! Risk of injury!
Between the load lifting equipment and structure!
–
Do not lean out of the load lifting equipment when moving.
–
Watch out for obstructions and protruding objects.
Risk of falling! Risk of being injured by falling objects!
The load or load lifting equipment may jam and fall!
–
Never stand beneath suspended loads.
–
Isolate the dangerous area whenever necessary.
–
Support and secure caught or jammed loads.
Risk of being crushed! Danger of being pulled in! Risk of injury!
On the wire rope and wire rope hoist!
–
Never touch the wire rope whilst the hoist is in operation! Do not reach into the inlet or outlet of the hoist.
Risk of being crushed! Risk of injury!
From the rotating motor shaft!
–
Check that the plugs on the motor cover (see Illustration 23, pos 3) are seated correctly.
Risk of being injured by falling objects!
Overloading can result in destruction of the hoist or the safety components! This can result in malfunctions!
–
Observe the maximum permitted load when loading the load lifting equipment.
–
Avoid excessive inching/jogging (e.g. giving the motor short impulses).
Risk of burns!
Motors can become hot during operation!
–
Do not touch the motors.
Danger of severe accidents!
Particular dangers exist when carrying out welding work.
–
You must always abide by the national safety and accident prevention regulations when carrying out welding work.
ATTENTION!
Incorrect rope lengths!
Can result in damage to the device!
The wire rope end connection, the load bearing point or the wire rope end itself must never be pulled up to or into the product or
the accessory parts!
–
Use a wire rope with adequate length.
–
Whenever necessary, monitor the wire rope during operation.
If you notice any abnormal noise in the gear of the hoist or if the motor hums intensively during UP or DOWN movement, stop use of
the TSAE immediately and contact trained and certified maintenance personnel for inspection.
7.1
Loading
DANGER!
Risk of being injured by falling objects!
–
Secure loads against falling.
–
Secure loads against twisting.
–
Switch on the on-site main switch or insert the CEE plug into the connector.
Содержание tirak L 500 P Series
