Installation
TR-Electronic GmbH 2020, All Rights Reserved
Printed in the Federal Republic of Germany
Page 56 of 88
TR - ELE - BA - DGB - 0030 - 01
06/15/2020
4.3 Connection - Notes
Mainly, the electrical characteristics are defined by the variable connection technique.
Whether the measuring system supports
● additional interfaces
● external inputs and outputs
● or a device heating
is therefore defined by the device specific pin assignment.
The connection can be made only in connection with the device specific pin
assignment!
At the delivery of the measuring system one device specific pin assignment in printed
form is enclosed and it can be downloaded afterwards from the page
„
www.tr-electronic.com/service/downloads/pin-assignments.html
”. The number of the
pin assignment is noted on the nameplate of the measuring system.
4.4 Device Status display (Run LED, Err LED)
Position and allocation of the LEDs have to be taken from the enclosed pin assignment!
Run LED (green)
Description
OFF
Voltage supply absent or too low
ON
Normal mode, measuring system OK
Err LED (red)
Description
OFF
No error present
ON
At least one measuring system - error occurred
For appropriate measures in case of error see chapter 9.1 "Optical displays" on page 79.
4.5 Parameterization via TRWinProg, SSI interface (optional)
Some parameters and limit values can be changed using the TRWinProg parameterization software.
All information about parameterization via TRWinProg and commissioning as well as the functions of
the optional SSI interface can be found in the SSI interface manual.
Download:
www.tr-electronic.de/f/TR-ELE-BA-DGB-0026
For parameters that can be changed via TRWinProg and IO-Link, only the value last
changed via the respective interface is valid.
This can lead to deviating values for the parameters set via TRWinProg and IO-Link.
The behavior of the measuring system can therefore deviate from the settings
displayed in TRWinProg.