TOX PRESSOTECHNIK Powerpackage Q Series, Оригинальная инструкция по эксплуатации, Страница: 36 / 80

Installation
36 TOX_Manual_Powerpackage_line-Q_en
ü
For connections see Pressure control in the power stroke line (assem-
bly ZDK) (optional).
1. Remove the screw plug on the control connection [12].
w
The lower positioned M 5 threaded hole is set free.
2. Remove the M5 screw plug from the par position.
3. Screw the M 5 screw plug fully into the lower positioned M 5 threaded
hole of the control connection [12].
w The M 5 threaded hole in power stroke valve is closed.
4. Connect control connection [12] on the power stroke valve to output of
fast approach stroke [4.1] or connection [4.4] on the pressure regulator.
In addition, install hose line and seal.
5. Install pressure regulator on power stroke input [1].
6. When installing a proportional pressure regulator, connect it to the con-
trol.
See data sheet, or circuit diagram.
6.3.5 Installing external power stroke connection (ZKHZ)
Material required:
Ÿ
Electrical switching valve power stroke switch (ZKHZ)
Ÿ
Screw plug
ü
For connections see External power stroke switch (assembly ZKHZ)
(optional).
1. Disassemble control throttle 'X'.
2. Connect the control throttle 'X' connection to screw plug.
3. Install power stroke switch to connection of the power stroke valve [14].
4. Connect the power stroke switch to permanent compressed air supply.
5. Connect the power stroke connection to the control.
See circuit diagram.