Town & Country Fireplaces TC54D, Инструкция по установке и эксплуатации

Страница: 16 / 44

5056.42562
Figure 25: Town & Country
wall switch.
Figure 26: Wall switch - interface side.
Figure 28: Vent mode selection switch.
Figure 27: Wall switch - battery side.
Linking the remote control unit to
the wall switch.
1. Begin by moving the selector
toggle on the wall switch to the
“REMOTE” position.
2. Insert a straightened paper clip
into the “PROGRAM” slot on the
wall switch.
3. Press the internal “PROGRAM”
button once and wait until you
hear 3 beeps from the wall switch.
4. Press the ON/OFF button of the
remote unit. Once the wall unit
beeps 3 times, the remote is
programmed.
5. The toggle on the wall switch
must be kept in the “REMOTE”
position in order to use the remote
control unit.
The NV / PV (Natural Vent / Power Vent) switch
(Figure 28) on the interface board (Figure 24) is set
according to which type of evacuating vent system
is present. If the fireplace is vented without the
assistance of a power vent, the switch should be
set to “NV”. If using a power vent, “PV” should be
selected. Follow the instructions provided with the
power vent kit for proper installation.
TO FIREPLACE
Wall Switch and Remote Control
Selecting Natural Vent and Power Vent Modes
16
TC54D _111215-44