Total TS42142101, Руководство пользователя

Страница: 16 / 18

and for framing ceilings. Always make a test cut on a piece of scrap wood before cutting
good material (fig. a).
1. Pull the shaft (2) and raise the saw arm to its maximum height.
2. Loosen the miter locks (15).
3. Rotate the miter table (12) until the pointer lines up with the desired angle on the
miter scale (13).
4. Retighten the miter locks (15).
Warning
Be sure to tighten the miter lock before making a cut. Failure to do so could cause the
table to move during the cut and cause serious personal injury.
5. Loosen the bevel lock (7) and move the saw arm (1) to the left to the desired
bevel angle (between 0º and 45º). Tighten the bevel lock (7).
6. Lay the workpiece flat on the table with one edge firmly against the fence (11). If
the board is warped, place the convex side against the fence. If the concave side
is placed against the fence, the board could break and jam the blade.
7. When cutting long pieces of wood, support the opposite end of the wood with
side support bars, a roller stand, or a work surface that is level with the saw table.
8. Before turning on the saw, perform a dry run of the cutting operation to verify that
there are no problems.
9. Hold the work handle (3) firmly and squeeze the switch trigger (16). Let the blade
reach full speed.
10. Press the release latch (17) and slowly lower the blade into and through the
workpiece.
11. Release the switch trigger (16) and allow the saw blade to stop rotating before
removing the blade from the workpiece. Wait until the blade stops before
removing the work piece.
Environment
Maintenance
Warning
Always make sure the tool is turned off and the plug is removed from the outlet before
making any adjustments or maintenance procedures.
Maintenance of the power cord
If it is necessary to replace the power cord, the task must be carried out by the
manufacturer, the manufacturer's agent or an authorized service center to avoid a safety
hazard.