Total TS42142101, Руководство пользователя

Страница: 14 / 18

Miter Saw Uses
Cross-section
A cross cut is made by cutting along the grain of the workpiece. A 90º cross cut is made
with the miter table at 0º. Miter crosscuts are made with the table set at a non-zero angle
(fig. X).
1. Pull the shaft (2) and raise the saw arm (1) to its maximum height.
2. Loosen the miter locks (15).
3. Rotate the miter table (12) until the pointer lines up with the desired angle.
4. Retighten the miter locks (15) (fig. Y).
Warning
Be sure to tighten the miter locks before making a cut. Failure to do so could cause the
table to move during the cut and cause serious personal injury.
5. Lay the workpiece flat on the table with one edge firmly against the fence (11). If
the board is warped, place the convex side against the guide (11). If the concave
side is placed against the fence, the board could break and jam the blade.
6. When cutting long pieces of wood, support the opposite end of the wood with
side support bars, a roller stand, or a work surface that is level with the saw table.
7. Before turning on the saw, perform a dry run of the cutting operation to verify that
there are no problems.
8. Firmly hold the work handle (3) and pull the switch trigger (16). Let the blade
reach full speed.