Total TS42142101, Руководство пользователя

Страница: 12 / 18

Change a blade
Attention
Never try to use a blade larger than the rated capacity of the saw. It could come into
contact with the blade guards. Never use a blade that is too thick to allow the outer blade
washer to engage with the flats on the shaft. That will not let the blade screw properly
secure the blade on the shaft. Do not use the saw to cut metal or masonry. Make sure
any arbor spacers and rings that may be required fit the arbor and mounted blade.
1. Make sure the electrical plug is disconnected from the outlet.
2. Press down on the work handle (3) and pull on the shaft (2) to disengage the saw
arm (1).
3. Raise the saw arm (1) to its highest position.
4. Using a Phillips head screwdriver, loosen and remove the Phillips head screw
that secures the guard retraction arm (6) to the rotary blade guard (5) (fig. Q).
5. Using a Phillips screwdriver, loosen the Phillips head screw that secures the
blade bolt cover (19) (fig. R).
6. Pull the rotary blade guard (5) down and then rotate it up along with the blade
bolt cover (19). When the rotary blade guard (5) is placed over the upper
stationary knife guard (4), the blade bolt can be accessed (fig. S).
7. Hold the swivel guard (5) up and press the spindle lock button (18). Rotate the
blade until the shaft locks (fig. T).
8. Use the 6mm hex key provided to loosen and remove the blade bolt. (Loosen
clockwise as the blade screw has a left hand thread) (fig. U).