Total TS42142101, Руководство пользователя

Страница: 10 / 18

8. Rotate the blade by hand and check the alignment of the blade with the table at
various points.
9. The edge of the square and the saw blade must be parallel.
10. If the saw blade runs off square, adjust as follows.
11. Use an 8mm wrench or adjustable wrench to loosen the jam nut that holds the 0°
bevel adjustment screw (10). Also, loosen the bevel lock (7) (fig. K).
12. Adjust the 0° bevel adjustment screw (10) with a 4mm hex key to align the blade
with the square (fig. L).
13. Loosen the Phillips head screw holding the bevel scale pointer (8) and adjust the
position of the pointer so that it accurately indicates zero on the scale. Retighten
the screw (fig. M).
14. Retighten the bevel lock (7) and jam nut holding the 0° bevel adjustment screw
(10).
Note. The above procedure can also be used to check the angle of the saw blade to the table at
a 45º bevel angle. The 45° bevel adjustment screw (9) is on the opposite side of the saw arm.