Toshiba RAS-5M34UAV-E, Руководство по обслуживанию

Страница: 91 / 146

– 91 –
10-6. Removing the Main Parts
Normally, the front panel, moving panel, and air flow
louvres do not need to be removed.
However, use the procedure below if removal of
these parts is necessary.
CAUTION
Before removing the front panel, moving panel, or
air flow louvres, be sure to stop operation of the air
conditioner and unplug the power supply.
10-6-1. Removing the Front Panel and
Moving Panel
1) Open the moving panel, and support the moving
panel by the panel support on the right side.
Fig. 10-6-1
2) Remove the 4 set screws on the front panel.
Fig. 10-6-2
3) Insert your thumb into the air outlet bottom
section, and lift up the front panel bottom.
4) Close the moving panel to remove the clips on
the top side as shown below.
Push your finger down on the clip on the front
panel top, and lift up the panel back edge so that
the clip is released (5 locations).
Fig. 10-6-3
Moving
panel
Front panel
Panel support
Clip
Clip
Clip
Clip
Clip
10-6-2. Removing the Moving Panel
1) Open the moving panel, and support the moving
panel by the panel support on the right side.
2) Remove the lead wire cover on the right side.
(1 screw)
Fig. 10-6-4
3) After removing a screw of the left-side panel
stopper, slide the panel stopper downwards.
Fig. 10-6-5
4) Grasp both sides of the moving panel, return the
panel support to its original position, and push
the left-side arm inwards with your finger.
Fig. 10-6-6
5) Pull out the moving panel towards the left side to
remove.
Fig. 10-6-7
Lead wire cover
Screw
Panel stopper
Screw