Toshiba RAS-09EAV-UL, Руководство по обслуживанию

Страница: 63 / 164

FILE NO. SVM-13069-3
*Remark :
Fig. 10- 4 -13
Control wire
Control wire
Remote controller
hanger
Remote controller
Screw (
∅
3.1 x 16L) for
hang remote controller
Wall
Screw (
∅
3.1 x 25L) for
to
battery cover
Remote controller
" #
Battery cover
Screw
$
Tighten fi rmly but
not over 0.15 N·m
(0.02 kgf·m)
<How to install the air inlet grille on the indoor unit>
• When attaching the air inlet grille, perform the same
process as for removal but in reverse order.
10-
4
-4. Piping and drain hose installation
<Piping and drain hose forming>
Fig. 10- 4 -14
– 63 –
WARNING :
Do not install batteries for hard wire installation
to connect remote control to the air conditioner.
1.
It is recommended to use double insulation lead wire
2.
For hard-wire operation, 1 remote control can control
only 1 indoor unit.
return to their initial condition when the user shuts
3.
In wire operation, (PRESET, TIMER and CLOCK will
down the power supply to the air conditioner.
CAUTION
Die-cutting Front panel slit
Changing drain hose
Piping preparation
Rear right
Rear left
Bottom left
Left
Bottom right
Right
Right
Rear right
Bottom
right
Rear
left
Bottom left
Left
2. Changing drain hose
For leftward connection, bottom - leftward connection
and rearleftward connection’s piping, it is necessary to
change the drain hose and drain cap.
How to remove the drain cap
Clip the drain cap with needle-nose pliers and pull out.
1. Die-cutting front panel slit
Heat insulator
Drain hose
How to remove the drain hose
Fig. 10- 4 -16
• The drain hose can be removed by removing the
screw securing the drain hose and then pulling out
the drain hose.
•
When removing the drain hose, be careful of any
sharp edges the steel plate may have. Sharp edges
can cause injuries.
•
To install the drain hose, insert the drain hose firmly
until the connection part contacts the heat insulator,
and the secure it with the original screw s .
With a pair, of nippers, cut out the slit on the leftward or
right side of the front panel for the left or right connection,
and the slit on the bottom left or right side of the front panel
for the bottom left ot right connection.
INSULATE BOTH LINES
Fig. 10- 4 -1 5
WARNING :
Do not install batteries for hard wire installation
EXPLOSION HAZARD