Toshiba RAS-09EAV-UL, Руководство по обслуживанию

Страница: 60 / 164

FILE NO. SVM-13069-3
10-
4
-2. Cutting a Hole and Mounting the
mounting Plate
Cutting a hole
When installing the refrigerant pipes from the rear.
∅ 2-9/16 in. (65 mm)
3-15/16 in.
Pipe
hole
Fig. 10-4-1
CAUTION
10- 4 . Indoor Unit
10-
4
-1. Installation Location
• A location which provides clearances around the
indoor unit as shown in the diagram in the
"CLEARANCES" section.
•
A location where there are no obstacles near the
air inlet and outlet.
•
A location which allows easy installation of the piping
to the outdoor unit.
• A location which allows the front panel to be opened
•
The indoor unit shall be installed such that the top
unit.
of the indoor unit comes to at least 6.6 ft (2 m) height.
Also avoid putting anything on the top of the indoor
CAUTION
• Direct sunlight on the indoor unit 's wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to RF noise sources.
(For details, see the owner's manual.)
After determining the pipe hole position on the
mounting plate (
ð
), drill the pipe hole
∅ 2-9/16 in.
( ∅ 65 mm) at a slight downward slant to the outdoor
side.
NOTE :
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
Mounting the mounting plate
Fig.
10
-
4
-2
When the installat
ing
plate is directly
mounted to the wall
1. To hook up the indoor unit, securely fit the
mounting plate onto the wall by screwing it in the
upper and lower parts.
2. To mount the mounting plate on a concrete wall
with , anchor bolts, drill the anchor bolt holes as
illustrated in the figure shown below.
3. Make sure the mounting plate is level ed .
CAUTION
When installing the mounting plate with a mounting
screw, do not use the anchor bolt holes.
Otherwise, the unit may fall down and result in
personal injury and property damage.
1
7
Anchor bolt holes
Hook
Hook
Hook
Pipe hole
Pipe hole
Mounting
plate
Mounting screw
Weight
Indoor unit
Thread
6.6 ft (2 m) or more
from
floor
7 in.
(170 mm)
3-11/32 in.
(85 mm)
2-
29
/6
4
in
.
(6
2
m
m
)
3-
17/
64
in
.
(82
.5
m
m)
Fig. 10-
4
-3
Anchor bolt
Projection
9/16 in. (15 mm)
Installation plate
(Keep horizontal direction.)
or less
– 60 –
•
A location that will bear the weight of the unit.
The cener of the pipe
hole is above he arrow
(100 mm)