271
9.7.
ITU T.37 and RFC2305
9.7.1.
Mode of Operation
The Unit conforms to the ITU T.37 standards and RFC2305. This Internet store and forward facsimile uses
approved IETF protocols for posting, relaying and delivery of documents. It requires no changes to Internet
standards or to ITU Facsimile Recommendations.
Store and forward facsimiles may operate in one of two modes.
Communicating in the Simple Mode as defined below provides inter operability. All terminals conforming to
this recommendation and capable of reception must be able to receive in Simple Mode. It is recommended
that terminals conforming to this recommendation and capable of transmitting should, as a minimum, be
capable of transmitting in Simple Mode.
Simple Mode supports the transfer of image data. Capability exchange and confirmation of receipt are not
required for Simple Mode but may be provided using optional email functions outside the scope of this
recommendation.
9.7.2.
Implementation Requirements for T.37 Simple Mode Table
Sender
Receiver
Required
Send data as a single MIME multi-page TIFF Profile S file
Provide notice in case of local transmission problem
Provide a return address of an Internet email receiver which is MIME
compliant
Strongly
Recommended
Include Message-ID
Use Base 64 encoding for image data
Optional
Use other TIFF Profiles if it has prior knowledge that such profiles are
supported by the receiver
Provide notice on receipt of DSN or other notifications
Required
Be MIME compliant except that it is not required to offer to place
MIME attachment in a file and may print a received file rather than
display
Be capable of processing multiple MIME TIFF Profile S image files
within a single message
Provide notice in case of reception or processing problems
Optional
Use other TIFF Profiles
Содержание e-STUDIO190F
