80
9.5.4 FW/BK ACT.
・
MODE1: Normal:
The printer waits for a next issue after media is forwarded fixed length.
B-EX6T1/T3:
16.5mm
B-EX4T1:
13.7mm
・
MODE2: SHORT CUT LAB: When the thermal transfer method and cut issue are selected, the printer
feeds 6-mm media backward, then waits for next issue with media forwarded
3-mm.
・
MODE3: for RFID:
The printer waits for a next issued after media is forwarded fixed length (to
prevent RFID media jam.)
B-EX6T1/T3:
34.0mm
B-EX4T1:
31.2mm
Notes:
1. When MODE2 is selected and the printer starts printing (feed) from the forwarded position, it feeds the
media for 3 mm from this position and temporarily stops. The feed speed for this 3-mm distance to the
home position is the max. speed that can be accelerated from the previous speed (See the following).
After the temporary stop, the printer prints or feeds the media at the specified speed.
B-EX6T1/T3
203-dpi model: 5 ips
B-EX6T1/T3
305-dpi model: 5 ips
B-EX4T1
203-dpi model: 6 ips
B-EX4T1
305-dpi model: 5 ips
* Except for the multi-step acceleration area for short-pitch labels, the print speed will be accelerated up to
the specified speed when the media has not been forwarded.
2. When MODE3 is selected and the RBN SAVE parameter is set to
“LABEL” or “TAG”, the printer will raise
the print head while the auto feed to the cut/strip position is performed.
If labels with the pitch of 57.2mm or less are used, they may peel off from the backing paper. Therefore, it
is required to select
“LABEL” or “TAG” for the RBN SAVE parameter. The speed of the auto feed is fixed
to 3 ips.
9.5.5 RIBBON SAVE
B-EX6T1/T3
・
OFF
The ribbon saving module is not used.
・
POSITION1
The ribbon saving module is used.(Head lever position:
“Position1”)
・
POSITION2
The ribbon saving module is used.(Head lever position:
“Position2”)
B-EX4T1
・
OFF
The ribbon saving module is not used.
・
TAG POSITION
The ribbon saving module is used.(Head lever position:
“TAG”)
・
LABEL POSITION The ribbon saving module is used.(Head lever position:
“LABEL”)
Notes:
1. If this parameter is set to
“POSITION1(TAG POSITION)” or “POSITION2(LABEL POSITION)” without
the ribbon saving module installed, the ribbon slacks and a print failure occurs. Caution required when
setting this parameter.
2. For B-EX6T1, only Position1 is available to use since there is no distinguish between TAG and LABEL.
3. If the actual lock position of the head opening / closing lever and the setting contents of this parameter
do not match, the ribbon save function may not operate normally.
9.5.6 HEAD UP CUT/RWD.
Содержание B-EX6T Series
Страница 104: ...103 9 6 3 SLANT LINE 3DOT 3 dot slant lines Magnification of slant lines 3 dot slant lines Black area ratio 16 7 ...
Страница 105: ...104 9 6 4 CHARACTERS Gothic Mincho Gothic Chinese 9 6 5 ...
Страница 106: ...105 9 6 5 BARCODE 9 6 6 NON PRINTING The printer feeds blank label 9 6 7 FACTORY TEST ...
