Toscana LINEAR GRAVITY FILLER, Инструкция по эксплуатации и техническому обслуживанию

Страница: 26 / 34

Instructions handbook 26
13.1 - Lighting
For the installation environment it is necessary to follow the regulation lighting criteria (ISO Std.
89953.89). The working area must be well lit to ensure that the operator has no difficulty in
working and all the cut-off, operating, control and emergency devices are always in sight.
In the event of poor workplace lighting, use portable lighting devices:
-
do not connect auxiliary lighting devices to the machine electric panel.
13.2 - Noise
It is necessary to follow the regulation noise criteria to ensure that the noise level produced by the
machine does not exceed the acceptable value (80dB) if it is installed in particular conditions. The
machine meets the regulation sound emission ratings.
The tests performed recorded the following noise pressure measured in the work positions shown
below:
Table 1 - Points of noise measurement
MEASUREMENT POSITION L
pA
dB[A]
P1 72
P1 Measurement performed at the OPERATOR POSITION, at a height of 1.55 m ± 0.075 m from
floor level.
Figure 17 – Working position
The test was conducted in normal machine working conditions with the automatic cycle, in an
industrial shed with Class 1 instrumentation (IEC804).
13.3 - Explosion or fire hazard
As mentioned in the risk analysis, the machine does not represent a fire hazard, but it must be
concerned by the analysis process on the basis of the environment and standards that rule this
application. In any case, the machine must not work in areas subjected to the danger of explosions.