Toscana LINEAR GRAVITY FILLER, Инструкция по эксплуатации и техническому обслуживанию

Страница: 17 / 34

Instructions handbook 17
10.0 – Operation and use
WARNING
Before starting the machine for the first time make sure that the cleaning, lubricating and
maintenance operations have been carried out.
- Connect the plug f the control board to the power supply net,
- Connect the machine piping to the product tank,
- Adjust the vat position accordingly to the kind of bottle used (ref.to chapter 10.3).
- Adjust the level of liquid into the bottle as per chapter 10.3.
10.1 – Vat regulation
You can regulate the vat height accordingly to
the bottles height and to the filling level
required: Move the vat up removing it from
the holes and place it up or down. Incline the
vat upward removing it out from the holes
sliding it up or down as required, than put it
back in position inside the proper holes on the
lateral side (look at the picture).
ATTENTION: Be sure that the
vat is re-aligned correctly.
Figure 10 – Vat regulation
10.2 – Level adjustment
In order to find the right level of product into
the bottle act as follows:
•
Screw or unscrew the ring-nut (A) to
obtain the desired level into the bottles.
•
We remind you that screwing
ANTICLOCKWISE the ring-nut the
level will be lower, screwing
CLOCKWISE the level will be higher.
•
We recommend to act on the ring-nut
with a minimum number of REV. to
avoid liquid overflowing.
Figure 11 – Level adjustment