Toscana LINEAR GRAVITY FILLER, Инструкция по эксплуатации и техническому обслуживанию

Страница: 18 / 34

Instructions handbook 18
ATTENTION: the ring-nut has always to be adjusted without the bottle placed under it.
10.3 – Starting and stopping the filler
STARTING THE FILLER
After you made the above mentioned operations
proceed as follows:
•
open valve (A),
•
remove cap (H) and fulfil with product the
pump body, than close it,
•
for the machines without electric board
move the PUMP switch (B) TO “ON” and
control that the light is on, for the models
without the panel board the flashing light is
placed on the pump,
•
for the machines with electric panel activate
the green push button (START or 1) after
having risen the emergency button to turn on
the machine.
•
IMPORTANT : verify the sense of rotation
looking at the side that is sucking,
•
rotate the filling valve ahead (C) and insert it
into the bottle, than place it on the vat (D),
•
proceed to discharge the fulfilled bottles and
to load the empty ones,
•
always control the filling level (E) of the
tank especially for the models without the
floating valve,
•
the filling valves of the filler can let drip
some drop of product inside the vat, that can
be emptied through the proper valve (F).
Figure 12 – Functioning commands
ATTENTION : If after some second after switching on of the machine the pump is not
priming control the connections of piping and fittings to verify that there are no air seepage.
STOPPING THE FILLER
To stop the machine proceed as follows:
•
Move PUMP switch to “OFF” or push the STOP key for the machines with EXTERNAL
BOARD
•
continue to bottle till the tank is completely empty, or discharge the tank through the proper
valve (G) for the total discharge,
For the filler washing refer to the following indications:
•
fulfil the tank with the desired washing product,
•
carry out the different filling phases for each filling valve.
We suggest you to carry out the washing phase first with water, than with specific products.