Page
20
1
2
3
4
5
6
STEP
14
Insert eight HOLE CAPS (13) into the top and
bottom holes of the LEFT and RIGHT DOOR
PIVOTS (24 & 27) and both FRONT DOOR
TUBES (22) as shown.
DOOR ADJUSTMENT
Close both doors by pulling on the spring pins
that are located at the top. Push doors closed
until both spring pins engage in closed position.
(Springs will force the doors out slightly) If the
doors are not aligned from top to bottom, loosen
the bolts on the FRAME CONNECTOR (21) and
do the following:
•
If the doors are wider at the bottom than
at the top, Pull FRAME CONNECTOR
towards the front of machine and re-
tighten bolts once the doors are aligned.
•
If the doors are wider at the top than the
bottom, Push FRAME CONNECTOR
towards the rear of the machine and
retighten bolts once the doors are
aligned.
13
27
22
13
24
22
DOOR
ADJUSTMENT
21
