Toro Z Master 4000 Series, Руководство по обслуживанию

Страница: 62 / 114

MYRIDE® Removal (continued)
g348084
Figure 42
11. Remove the ½ inch carriage bolt from the shock mount while supporting the
front MYRIDE subframe. Reinstall the ½ inch carriage bolt with the MYRIDE
subframe resting against the shock and tighten.
g346226
Figure 43
12. Lower the ROPS to the full-down position.
13. Fully remove the 2 (3/8 inch) locks nuts securing the lower front rear shocks
to the ROPS (previously loosened).
14. Using an appropriate lifting device, slightly raise the MYRIDE assembly and
slide the rear shocks off the mount studs, move to the side.
15. Fully raise the MYRIDE assembly out of the machine.
MYRIDE® Installation
1. Using an appropriate lifting device, Install the MYRIDE assembly into the
machine.
2. Raise the ROPS.
3. Install and tighten the ½ inch carriage bolt to the shock mount while
supporting the front MYRIDE subframe.
Note: Do not over-tighten the carriage bolt. The shock must pivot freely.
Chassis: Service and Repairs Page 5–22 4000 Series Z MASTER® Service Manual
3442-427 Rev A